Build Your Own Automotive Driveshaft

2 Key elements:

1-Determine the correct slip yoke for your transmission.

Some transmissions require additional measurements. Your slip yoke determines the universal joint size. <click here for a list of transmission yokes>

 

2-Determine the universal joint size needed to fit your pinion yoke.

< click here to measure the differential yoke to determine universal joint size> 

<click here for a list of pinion yokes>

 

Step 1: Measurements

From the drawing above:

X=

Y=

	Select Tube Size and type:                 The following is a conservative, general guide only.
2.50"x.065	For lengths less than 30"
2.50"x.083	For lengths less than 30" (1350 series & 1410 series)
3.00"x.065	For lengths between 30" and 50"
3.00"x.083	For lengths between 30" and 50" (1350 series & 1410 series)
3.50"x.065	For lengths between 50" and 60"
3.50"x.083	For lengths between 50" and 60" (1350 series & 1410 series)
4.00"x.065	For lengths between 60" and 70"
4.00"x.083	For lengths between 60" and 70" (1350 series & 1410 series)
Aluminum	For lengths less than 40" *** 3.50x.125
Aluminum	For lengths between 40" and 70" *** 4.00x.125
Aluminum	For lengths over 70" or if desired *** 5.00x.083

Guess what ?

If you know the specifications of the drive shaft you need, we can build and ship it to your door.

Aluminum or steel, high performance or stock.

Almost all orders are filled within 24 hours. Many times even sooner.